Can Durgut

-Project during the internship: Sheet Metal Mold Steel by Induction Heat Treatment Hardening -Induction surface hardening of 1.7140 and 1.2602 materials was performed experimentally with different cooling methods and different application rates and the hardness values at different depths were measured by removing chips from the surfaces to decide best cooling method and feed rate by comparing hardness values and stability. - Tools: AutoCad, MS Office, Flir E40, MIC 10

Discovering of the Toyota Production System at the body assembly line. Terms: Just-in-Time, Jidoka, Kanban, Muda, Muri, Mura, Genba, Genchi Genbutsu, Heijunka, Andon, Kaizen, Konnyaku Stone, Poka-Yoke, Hansei, Nemawashi

-Project: Efficient use of autonomous line following robots. -Detection of error frequencies and locations of robots, time calculations, investigation of each robot separately and solution ideas. Tools: MS Office, AutoCAD

-Master thesis: Determination of Process Limitations for Laser Beam Melting and Optimization of Additive Manufacturing Lab Wiki -The additive manufacturing process of laser beam melting was investigated. Test specimens were manufactured and assessed using measurement equipments. Geometric accuracy, surface roughness, and the feasibility of geometries has been gained. -Tools: Autodesk Fusion 360, NX, MS Office, Trumpf TruPrint 1000, TruTops Print, ZEISS C 400 CMM, ZEISS Smartzoom 5, MarSurf XR1

Erasmus exchange program

-Bachelor thesis: Sheet Metal Mold Steel by Induction Heat Treatment Hardening -Induction surface hardening of 1.7140 and 1.2602 materials was performed experimentally with different cooling methods and different application rates and the hardness values at different depths were measured by removing chips from the surfaces to decide best cooling method and feed rate by comparing hardness values and stability. - Tools: AutoCad, MS Office, Flir E40, MIC 10