Pruthviraj korwar

A320 Installation drawings for Diehl Cabin interiors • Design of raster & mark the no. of detail sheets vital for one drawing set. • Creation of raster & detail sheets with all the necessary NOTAs & Salmiz. • Creating or modifying drawings for 928, VKM & 924 as per TRS & BM. • Itemizing all the installations with the right screws, nuts & washer’s sizes. • Creating & updating BOM & ECN in excel & feeding that data in TAKSY.

Electrical Harness Installation drawings for Airbus A320 • Design of raster & mark the no. of detail sheets vital for one drawing set. • Creation of raster & detail sheets with all the necessary NOTAs & Salmiz. • Creating or modifying drawings for 928, VKM & 924 as per TRS & BM. • Itemizing all the installations with the right screws, nuts & washer’s sizes. • Creating & updating BOM & ECN in excel & feeding that data in TAKSY.

Electrical Harness GRM Project for AIRBUS A350 XWB-900 • Expertise in 3D harness routing and installation design upper & lower deck as Per SIDP. • Creation of product structure for V928 & V929. • TRS, DQN, RDR, DQC implementation for different MSNs for A350. • Creation of V924 Parts, Ramps & IP management based on requirement.

Airbus Smart 3D structural design for Airbus A320 • Creation of 3D models from existing 2D data for primary & secondary structure in DMU for A320 Neo. • Requisite Study for installation of brackets at different sections of aircraft. • Creating mock up data in section S15 & 16/18 for A320. • Validating existing 3D models as per 2D.

ATA25 Lavatories & stowage Design & Drawings A350 XWB-900. • Studying of Airbus technical & color specification documents. • 3D modeling & 2D drafting of composite panels, bonding group, parts inside the Lavatories such as cabinets, pelmets, washbasin unit, doors. • Creation of installation & GAD drawings & bill of material.

ATA 21 Air Duct & Brackets Design & Drawings for A350 XWB-900 • Project involves modelling of air ducting & bracketing from SAM model by airbus methodology following Diehl standards. • Creation of installation drawings for designed 3D parts, Assembly and Sub Assembly of Ducts & brackets. • Defining the composite layer setup for the ducting as per pressure zone. • Creating their BOM, drawing data set & Entering the attributes in PDMSSCI Link.

Designing of fuselage for MRJ 90 • Generation of Model Based Definition (MBD). • Execution of installation definition models (IDM) for fuselage parts. • Execution of Evidence Reports for fuselage parts.

Design of turbine rotor blade for Rolls Royce (RB211) Engine • Modeling of Turbine rotor blades for Rolls Royce engine. • Approval of design by discussion with Production and Quality Departments. • Detailing of component drawing for manufacturing feasibility.

Mechanical