Suhel Lodha

-Working on HW ECU design circuitry of BLDC Motor for Engine cooling fan for Automotive Electronics at Buehlertal, Germany. -High and low side Gate driver circuits, MOSFET functional behaviour, optimisation of switching losses and EMI design dv/dt and di/dt, conduction losses, dead time config, Gate charge loss, Body diode loss. -Circuit simulation using Saber RD, Pspice

-Worked on HW design of single/three phase Photo-voltaic Inverter. -Worked in Power electronics domain. Various Bridge topologies -Design Expertise in Buck, Boost, Buck-boost (Flyback) DC-DC converters. -Experience in Single Phase -Photovoltaic Inverters (DC to AC) circuits. -Various Micro-controller interface circuits

-Worked on HW design for Wheel Alignment reference system for Automotive Aftermarket division. -Worked in opto-electronics domain and with MEMS, CCD and PSD sensors technology. -Experience in designing mixed signal circuit boards with 8, 16, 32 bit processors / microcontrollers with technical trade-off analysis between performance and cost and the ability to be able to estimate final costs. -Sound knowledge of HW circuits for CAN, USB, I2C, SPI.

-Hardware Design Engineer in Intelligent Fault Monitor system project activities. -Responsible for Adaptive Ventile electronic board design- delivered Requirement Study and Analysis. Components selection. Schematic verification. Coordinated with the Layout team for the Placement and routing. Coordinated with the EMS vendor for the procurement of components. Unit Test plan development for the Boards. Coordinated with software team in board bring up.

Power Electronics, Analog Design, Digital design, wireless communications, electronic circuits, Logic design, Embedded design